Showing all 17 results
EdenPURE GEN4A4643/RTL Heater Troubleshooting
Yes. You can purchase replacement heating elements for your GEN4A4643/RTL from AirNmore by visiting our US001 Sylvania Heater Bulbs, Set of 3 Bulbs product page. Our bulb kit meets or exceeds OEM specifications.
The EdenPURE GEN4A4643/RTL heater is designed to exhaust all heat when the heater goes in to cool down mode. Cool down mode occurs when you turn off the unit or once the heater has achieved the desired temperature.
Like most edenpure heaters, the GEN4A4643/RTL is designed to circulate air in your environment every few minutes. This is even if your desired temperature has been reached. This cycle occurs every three minutes for about 20 seconds.
To reset the EdenPURE GEN4A4643/RTL heater, which will reset the internal electronics, you should unplug the power from the wall for at least 30 minutes.
The GEN4A4643/RTL heater is equipped with a washable, lifetime filter which is easy to clean. It is recommended that the filter be cleaned regularly or as needed.
To clean the filter, follow the following steps:
- Remove the filter from the back of the GEN4A4643/RTL.
- Vacuum the filter.
- Rinse the filter in a sink with warm water. Do not use a high pressure water source or use any soaps or detergents.
- Your filter must be dry before re-installing in your GEN4A4643/RTL heater. It’s not recommended to dry the filter with an appliance such as a hair dryer. Air dry is recommended.
If you have any questions, please contact us by phone at 800.707.8725 or by filling out the form below: