EdenPURE GEN 3 A4136/RTL Parts
This is a complete list of compatible replacement parts for the EdenPURE GEN 3 A4136/RTL Heater that we have in stock. AirNmore is customer service focused. We have also been servicing EdenPURE heaters for over 10 years. If you have any questions, please call us at 800-707-8725. Model number: A4136/RTL
This is a complete list of compatible replacement parts for the EdenPURE GEN 3 A4136/RTL Heater that we have in stock. AirNmore is customer service focused. We have also been servicing EdenPURE heaters for over 10 years. If you have any questions, please call us at 800-707-8725.
Model number: A4136/RTL
Showing all 25 results
EdenPURE GEN 3 A4136/RTL Heater Troubleshooting
The EdenPURE GEN 3 A4136/RTL heater is designed to exhaust all heat when the heater goes in to cool down mode. Cool down mode occurs when you turn off the unit or once the heater has achieved the desired temperature.
Like most edenpure heaters, the GEN 3 A4136/RTL is designed to circulate air in your environment every few minutes. This is even if your desired temperature has been reached. This cycle occurs every three minutes for about 20 seconds.
To reset the GEN 3 A4136/RTL heater, which will reset the internal electronics, you should unplug the power from the wall for at least 30 minutes.
Check the master power switch and make sure it is set to the OFF position. Also, please be advised that when you turn the heater off, the fans will continue to run for a few minutes so that the EdenPURE GEN 3 A4136/RTL cools down. Once the heat chambers have cooled down, the fan and heater will shut off automatically.
Yes. You can purchase replacement heating elements from AirNmore by visiting our Heating Element Bulb Kit, Set of 6 product page. Our bulb kit meets or exceeds OEM specifications.
If you need assistance replacing the heating element in your GEN 3 A4136/RTL, we have developed a video that provides instructions on how to do so.
The GEN 3 A4136/RTL heater is equipped with a washable, lifetime filter which is easy to clean. It is recommended that the filter be cleaned regularly or as needed.
To clean the filter, follow the following steps:
- Remove the filter from the GEN 3 Model A4136/RTL.
- Vacuum the filter.
- Rinse the filter in a sink with warm water. Do not use a high pressure water source or use any soaps or detergents.
- Your filter must be dry before re-installing in your GEN 3 A4136/RTL heater. It’s not recommended to dry the filter with an appliance such as a hair dryer. Air dry is recommended.
To purchase a replacement filter, purchase the following filter.
If you have any questions, please contact us by phone at 800.707.8725 or by filling out the form below: